Control
Function
Default/Range
Master Bypass
Bypasses all of the Auto-Pan's controls.
Unmuted / Muted
Stereo Spread
(%)
Available when the I/O Configuration Property is set to Stereo In/Stereo Out.
Determines the separation spread between the channels. 0% is equal amount of each channel mixed to the other, 100% is complete separation of the channels.
Default = 100
0 - 100
High-Pass
(Hz)
Frequencies below this frequency are attenuated. All frequencies above this frequency are amplified based on the setting of the Wet Gain control.
Default = 7,500
Range = 10 - 20,000
Low-Pass
(Hz)
Frequencies above this frequency are attenuated. All frequencies below this frequency are amplified based on the setting of the Wet Gain control.
Default = 5,000
Range = 10 - 20,000
LFO Freq
(Hz)
The frequency at which the LFO produces the waveform, or LFO Shape. The LFO Frequency controls the speed of the pan.
Default = 3.20
Range = 0.01 - 120
LFO Shape
You can select one of 4 different waveforms to control the shape of the pan envelope.
Default = Sine
Range = Sine, Saw Up, Saw Down, Triangle
LFO Stereo Spread
(%)
The LFO produces two synchronized waveforms, one for each output channel. The LFO Spread determines the phase shift between these two waveforms. 0% is in phase, 100% is 180° out of phase.
When the waveforms are in phase, left audio is panned hard left and the right audio is panned hard right then both into the middle. When the waveforms are out of phase, the left audio is panned hard left and the right audio panned hard left as well, then both to the right side.
Default = 100
Range = 0 - 100
Depth
(%)
The amount or Depth of the pan modulation. When the Depth control is at 0%, the left input does not pan to the right output, and the right input does not pan to the left. When the control is at 100%, the left input pans fully to the right output, and the right pans fully to the left.
Default = 100
Range = 0 - 100
Wet Solo
When engaged, allows you to listen to the wet signal by itself.
Normal / Solo
Wet Gain
(dB)
Controls the gain of the wet output.
Default = 0
Range = -100 - 20
Dry/Wet Mix
(%)
The percentage of wet to dry signal sent to the output. 0% is all dry signal, and no wet. 100% is all wet, and no dry.
Default = 50.0
Range = 0 - 100
